SERIES BOP HIGH POWER
 |
TOUR
|
| MODELS |
 |
| FEATURES |
| FUNCTION GENERATOR CHARACTERISTICS |
| LOCAL OPERATION |
| CONTROL |
| INTERFACE CHARACTERISTICS |
|
PROGRAMMING/ DISPLAY CHARACTERISTICS
|
| GENERAL SPECIFICATIONS |
| INPUT CHARACTERISTICS |
| OUTPUT CHARACTERISTICS |
| PHYSICAL CHARACTERISTICS |
| MANUALS |
| BOP 1 KILOWATT PROGRAMMING/DISPLAY CHARACTERISTICS | |||
| SPECIFICATION | RATING | DESCRIPTION | |
| Analog I/O Port |
main channel voltage or current |
-10V to +10V | Full range output, 20K Ohm input impedance |
| protection limit
channels ±voltage, ±current |
0.05V to +10V | O.5% to 100% of nominal range. Input vottage clamped to 12V through 1K Ohms. Maximum of 0.15mA input current at 1V input voltage. | |
| mode control |
Voltage: open circuit or TTL logic 1 Current: short circuit or TTL logic 0 |
Available only when digitally activated through power-up setting | |
| output current analog readback |
0 to ±10 Volts corresponds to zero to ± full scale nominal output current | Output impedance of this signal is 2K Ohms. | |
| External Protection I/O Port |
external shutdown | Isolated input for shutdown of the BOP (latched status) | Pulse width: 100 microseconds min. Action delay: 100 microseconds max. Restore operation by cycling input power or pressing RESET key(1). |
| external shutdown flag |
Isolated input indicating shutdown status | Action delay: 100 microseconds max. | |
| external on-off flag or external trigger |
flag: Isolated output indicating
output on (enabled,
STANDBY off) or off
(disabled, STANDBY on) status Trigger: Isolated trigger output for external devices |
Flag: LIST:SET:TRIG enables trigger function Flag action delay: 200 milliseconds max. Trigger: LIST:CLE disables trigger and restores flag. Trigger output pulse duration: settable between 0.25 to 34mS. Trigger output action delay: 100 microseconds max Trigger output active level: settable to either 0 or 1. |
|
| (1) | RESET key applies only to MG and ME models. |
