| BOP 1 KILOWATT INPUT CHARACTERISTICS | |||
| SPECIFICATION | RATING/DESCRIPTION | CONDITION | |
| a-c voltage | Nominal | 200/220/230/240Va-c (1)) (200-240 Va-c) |
No setting required. Single phase or between 2 phases of a 3-phase system within 200-240Va-c. |
| Range | 176-264V a-c | ||
| Frequency | Nominal | 50/60 Hz | |
| Range | 47 - 63 Hz | ||
| Current | 176V a-c | 9.5A (7.5A (2)) | Maximum |
| 264V a-c | 6.4A (4.4A (2)) | Maximum | |
| Power Factor | Source | 0.99 | Nominal output power |
| Sink | 0.97 | ||
| Efficiency | Source |
65% to 75% (model dependent) 56%/65% (3) |
Minimum value, @Nominal sourced output power (V-I quadrant 1 & 3) |
| Sink |
50% to 65% (model dependent) 45%/43% (3) |
Minimum value, @Nominal sink output power (V-I quadrant 2 & 4) | |
| Switching Frequency | 70 KHz ±5% (50 KHz ±5% (2)) |
Active PFC for source and sink. | |
| EMC Compliance | EN 61326-1 (1997) | Class A equipment | |
| EMC Immunity |
ESD | EN61000-4-2 | Electrostatic discharge |
| Radiated RF | EN61000-4-3 | ||
| EFT | EN61000-4-4 | Electrical fast transient/burst | |
| Surges | EN61000-4-5 | ||
| Conducted RF | EN61000-4-6 | ||
| EMC Emissions |
Conducted | EN61000-3-2 | Harmonics |
| EN61000-3-4 | Fluctuation and flicker | ||
| Conducted | EN55011/CISPR11 | 0.15 to 30 MHz | |
| Radiated | EN55011/CISPR11 | 30 to 1000 MHz | |
| Leakage Current | 3.5 mA | 230V a-c, 47 - 63Hz | |
| Insulation Coordination |
Input | Installation Category II | For TN or TT Power System |
| Overvoltage Category II | |||
| Output | Installation Category II | Maximum 300V (500V for 10V models) common mode voltage between output terminals and chassis ground | |
| Overvoltage Category II | |||
| Pollution Degree | 2 | ||
| (1) | All specifications listed in this table are for 230V a-c input voltage. |
| (2) | Specifications in parentheses apply to BOP 6-125MG/ME only. |
| (3) | BOP 6-125MG/ME and BOP 10-75MG/ME only. |
