| KLN 10kW EXTENDED RANGE MODEL TABLE | |||||||||
| MODEL (1) |
Max Power |
Rated Voltage (Volts) |
Maximum Current (Amperes) for Rated Voltage |
Rated Current (Amperes) |
Maximum Voltage (Volts) for Rated Current |
Ripple and Noise |
Internal Resistance Range (Ohms) |
|
|
| (V1) (2) | (A1) (2) | (A2) (2) | (V2) (2) |
CV (mV rms) |
CC (mA rms) |
||||
| KLN 80-360E | 10kW | 0 - 80 | 120 | 0 - 360 | 27.78 | 25 | 170 | 0 ~ 0.222 | |
| KLN 250-120E | 10kW | 0 - 250 | 40 | 0 - 120 | 83.33 | 50 | 36 | 0 ~ 2.080 | |
| KLN 350-84E | 10kW | 0 - 350 | 28.56 | 0 - 84 | 119.05 | 60 | 34 | 0 ~ 4.170 | |
| KLN 500-60E | 10kW | 0 - 500 | 20 | 0 - 60 | 166.67 | 70 | 32 | 0 ~ 8.330 | |
| KLN 650-46E | 10kW | 0 - 650 | 15.38 | 0 - 46 | 217.39 | 170 | 32 | 0 ~ 14.10 | |
| KLN 1000-30E | 10kW | 0 - 1000 | 10 | 0 - 30 | 333.3 | 350 | 22 | 0 ~ 33.30 | |
| NOTES: | |
| (1) |
For the 10kW KLN Extended Range Series each Model number KLN [ V ] - [ C ] [ X ] describes Rated Voltage, Rated Current and Interface where V = Rated Voltage in Volts, C = Rated Current in Amperes, X = Interface(s) included, where E = LAN (LXI) standard on all models G = LAN (LXI) plus optional GPIB U = LAN (LXI) plus optional USB S = LAN (LXI) plus optional Serial Port (RS 422/RS 485) A = LAN (LXI) plus optional Isolated Analog As an example, KLN 80-360E is a 10kW model with Rated Voltage = 80V, Rated Current = 360A with LAN (LXI) interface. |
| (2) |
Referring to the figure above, a conventional output power range would require three power supplies to meet the following requirements: V x A = Rated Power, V1 x A1 = Rated Power, V2 x A2 = Rated Power The constant power technique used by the KLN Wide Range Series allows a single power supply to meet the three requirements noted above for V x A, V1 x A1 and V2 x A2, plus all points within the area beneath the arc formed by "A", "B" and "C". This is possible because the maximum voltage and current are not fixed, but are limited by the maximum power of the KLN Wide Range power supply. |
