SERIES KLP
 |
TOUR
|
| MODELS |
 |
 |
| FEATURES |
| INPUT CHARACTERISTICS |
| OUTPUT CHARACTERISTICS |
| RAPID OUTPUT DISCHARGE |
| GENERAL SPECIFICATIONS |
|
PROGRAMMING CHARACTERISTICS |
| PHYSICAL CHARACTERISTICS |
| MANUALS |
| KLP PROGRAMMING CHARACTERISTICS (DIGITAL) | |||
| Specification | Rating/Description | Condition | |
| Supported Interfaces |
standard models: | GPIB and RS 232 | Support SCPI command set for GPIB and RS 232 (see KLP Developer's Guide) |
| E-Series models: |
GPIB and LAN Support four interfaces for LAN: 1. Web interface, port 80 2. SCPI Telnet, port 5024 3. SCPI Sockets, port 5025 4. VXI 11, port 1024 |
Support SCPI command set for GPIB and LAN; (see KLP Developer's Guide) | |
| GPIB | GPIB address range: 1 to 30 | Factory default is 6. | |
| RS 232 | standard models only: | Baud Rate range: 2400, 4800, 9600, 19,200 or 38,400 | Factory default is 38,400. |
| Digital remote control |
isolation: | Safety Extra Low Voltage (SELV) | |
| format: | compatible with SCPI protocols | W98 SE and later operating systems. | |
| Programming resolution | 0.024% of Emax and Imax | ||
| Programming accuracy | 0.05% of Emax and Imax | ||
| Readback resolution | 0.024% of Emax and Imax | ||
| Readback accuracy | Either 0.1% of Emax and Imax or front panel voltmeter or ammeter display resolution, whichever is greater. (1) | ±1 LSB | |
| Status reporting |
OVP, OCP, OTP, output lead fault (OLF), fan failure, power loss |
Detected fault shuts down power supply output. Overvoltage and overcurrent protection values can be individually proogrammed. | |
