SERIES KLP
 |
TOUR
|
| MODELS |
 |
 |
| FEATURES |
| INPUT CHARACTERISTICS |
| OUTPUT CHARACTERISTICS |
| RAPID OUTPUT DISCHARGE |
| GENERAL SPECIFICATIONS |
|
PROGRAMMING CHARACTERISTICS |
| PHYSICAL CHARACTERISTICS |
| MANUALS |
| KLP PROGRAMMING CHARACTERISTICS (ANALOG) | |||
| Specification | Rating/Description | Condition | |
| Analog remote control |
selection: | Activate with jumper at analog programming connector | Recognized during power up. |
| isolation: | Safety Extra Low Voltage (SELV) | ||
|
Analog Input Update Rate |
2Hz (0.5 Second) Applies to programming by voltage/ resistance and readback specifications. | Analog input voltage digitized (12-bit resolution), optically isolated, then processed by digital section. | |
| Programming by voltage |
voltage: | 0-10V | Voltage equivalent to Full Scale can be reduced by the user. |
| current: | 0-10V | See Model Table for minimum programmable current. Voltage equivalent to Full Scale can be reduced by the user. | |
| Programming by resistance |
voltage: | 0-10K ohms | Resistance equivalent to Full Scale can be reduced by the user. |
| current: | 0-10K ohms | See Model Table for minimum programmable current. Resistance equivalent to Full Scale can be reduced by the user. | |
| Readback | 0-10V proportional signal | Proportional to analog control voltage/resistance. | |
| Remote inhibit | TTL compatible | Dual polarity, can be active (inhibit the output) for either a TTL high or low) | |
| Composite status flag | Isolated form C contacts | Programmable. Flags either a) system fault, b) transition from CV to CC mode or c) transition from CC to CV mode. | |
