SERIES BOP
|
|
TOUR
|
|
| MODELS | |
| TUTORIAL VIDEO | |
 |
|
 |
|
| FEATURES | |
| REAR PROGRAMMING CONNECTORS |
|
| GENERAL SPECIFICATIONS |
|
| STATIC SPECIFICATIONS |
|
| DYNAMIC SPECIFICATIONS |
|
| OUTLINE DIMENSIONS |
|
| MANUALS | |
| BIT CARDS (REMOTE CONTROL) |
When BIT cards are installed, the computer interfaces (GPIB. LAN) use 16 bit Digital to Analog circuits to control the BOP units. When these interfaces are installed, refer to model-specific specifications of the combined BOP with BIT card.
| BOP STATIC SPECIFICATIONS | |||||||||
| INFLUENCE QUANTITY | OUTPUT EFFECTS (1) |
PREAMPLIFIER OFFSETS (4) |
REFERENCE ±10V |
||||||
| VOLTAGE MODE | CURRENT MODE | ||||||||
| TYPICAL | MAXIMUM | TYPICAL | MAXIMUM | ΔEio | ΔIio | ||||
| Source Voltage (min.-max.) | <0.0005% EO max | 0.001% EO max | <0.002% IO max | 0.005% IO max | <5μV | <1nA | <0.0005% | ||
| Load (no load-full load) | <0.001% EO max (7) | 0.002% EO max (7) | <0.5mA | 1mA | --- | --- | <0.0005% | ||
| Time (8-hour drift) | <0.005% EO max | 0.01% EO max | <0.01% IO max | 0.02% IO max | <20μV | <1nA | <0.005% | ||
| Temperature, per °C | <0.005% EO max | 0.01% EO max | <0.01% IO max | 0.02% IO max | <20μV | <1nA | <0.005% | ||
| Ripple and Noise (2) |
rms | <1mV | 3mV (5) (6) | <0.01% IO max | 0.03% IO max | --- | --- | --- | |
| p-p (3) | <10mV | 30mV (5) (6) | <0.1% IO max | 0.3% IO max | --- | --- | --- | ||
| (1) | Output effects, expressaed as a percentage, re referred to the minimum rated output voltage or curent, |
| (2) | Measured with the common terminal grounded so that the common mode current does not flow through the load. |
| (3) | Peak-to-peak ripple is measured over a 20Hz to 10MHz bandwidth. |
| (4) |
The output effect can be calculated by the relationship: ΔEO = ±ΔEr (Rf/Ri) ±ΔEio (1+Rf/Ri) ±ΔIio (Rf) where Rf is the feedback resistor and Ri is the input resistor from the reference Er. |
| (5) | For BOP 200-1M the maximum ripple and noise is 5mV rms and 50mV p-p. |
| (6) | For all BOP models (except BOP 200-1M) with BIT card installed: typical voltage mode ripple/noise = 4mV rms, max noise = 6mV rms and 60mV p-p, For BOP 200-1 models with BIT card installed: typical voltage mode ripple/noise = 4mV rms, max voltage mode ripple/noise = 8mV rms and 80mV p-p. |
| (6) | For BOP 5-20DL, typical voltage mode output effects = 0.004%, maximum voltage mode output effects = 0.008%. |
