Custom Power Assembly Rear Panel Components

RCP 2-1: 1 a-c Inlet only, 15 Amp (See Note 2)
RCP 3-4: 3 Barrier Strips (45 Terminals, 20 Amps/ Terminal)
RCP 4-4: 4 Barrier Strips (36 Terminals, 20 Amps/Terminal), Two 150 Amp Connector Studs (See Note 3)
RCP 5-2: Vent Panel
RCP 5-3: Vent Panel
RCP 10-2: 3 wire a-c Input with Mating Connector (See Note 1)
RCP 11-2: 115V 1 * 3 wire a-c Input with Mating Connector & 20 Amp Line Cord
RCP 12-2: 115V 1 * 3 wire a-c Input with Mating Connector & 30 Amp Line Cord
RCP 13-2: 7 wire a-c Input with Mating Connector (See Note 1)

RCP 14-4: Fan, 115V 1 * (230V a-c optional), 3 wire a-c Input with Mating Connector (See Note 1)
RCP 15-4: Fan, 115V 1 * 3 wire a-c Input with Mating Connector & 20 Amp Line Cord
RCP 16-4: Fan, 115V 1 * 3 wire a-c Input with Mating Connector & 30 Amp Line Cord
RCP 17-4: Fan, 115V 1 * 7 wire a-c Input with Mating Connector
RCP 19-1: a-c or d-c Inlet, 30 Amp, Barrier Strip, with Strain Relief Clamp (See Note 2 )
RCP 20-4: a-c or d-c Inlet, 30 Amp, Barrier Strip, with Strain Relief Clamp, Fan (See Note 2)
RCP 21-4: Fan, 115V, a-c Inlet, 15 Amp, (See Note 2)

RCP 8-4: 1 Barrier Strip (15 Terminals, 20 Amps/Terminal)
RCP 9-4: 2 Barrier Strips (30 Terminals, 20 Amps/Terminal)
RCP 18-4: Two 600 Amp Terminals with two 7-Terminal Barrier Strips, 20 Amps/Terminal

NOTES:

1. Consult factory for line cord requirement.
2. Does not mount in extreme left position.
3. Does not mount in extreme right position.
4. Suffix number -1, -2, -3, etc. indicates the panel width in increments of 1/8 for standard 19" panel.
   Example: RCP -2-1 is a 1/8 width panel; RCP 10-2 is a 1/4 width panel, etc.